Afternoon!
If anyone still reads
this, I have been a bit lapse at saying what I’ve done and actually doing the work.
However, I do have an excuse, I became a father. So, for the work I have
done, I’ve reworked the bulb calculations and done both sides now:
I’ve added a nut to the
bulb, but it’s going to be very expensive and hard to get hold of, so I’m going
to use a cap screw with a standard, flat, spring and nut. These are to be
decided but the pic above sows the nut to be removed.
I’ve added the Nylock
nuts put in place on the mast support:
These nuts will either
be welded or glued into place, I haven’t decided which way to go yet.
And finally, I’ve
started on the rear bulb, but it looks rubbish and needs reworking.
Next Steps
·
Complete the Rear bulb on boat
·
Sail boom supports
·
Sail top support
·
Hole in rib section for keel plate.
·
Inserts on backbone to support keel plate.
Until next time (whenever that will be), enjoy!